New install - No Audio/sound JY-HQS01N4G-1
#1
Hi, I've just bought a JY-HQS01N4G-1 and tried to install it today.

I'm installing it in an Abarth 695 from 2012 and I'm using the Connect2 harness for steering wheel controls.

Everything seems to work fine, except that there is no audio/sound at all. Not from any source. No screen click, no FM radio, no YouTube audio, no nothing. I've tried a factory reset, but still no audio.

I have checked the schematics on the old radio and made sure that the lines for the speakers are wired correctly and everything seems to be correct.

So what to do? How do I get audio?
  Reply
#2
This is the OEM stereo in the car. I suspect that the amplifier is not activated and therefore there is no sound, correct? So how do I connect the amplifier?


Attached Files Thumbnail(s)
   
  Reply
#3
(12-22-2020, 05:06 PM)Abarth695 Wrote:  This is the OEM stereo in the car. I suspect that the amplifier is not activated and therefore there is no sound, correct? So how do I connect the amplifier?

You can try to connect the "AMP.CONT wire with the amplifier wire".
  Reply
#4
(12-29-2020, 08:00 AM)admin Wrote:  
(12-22-2020, 05:06 PM)Abarth695 Wrote:  This is the OEM stereo in the car. I suspect that the amplifier is not activated and therefore there is no sound, correct? So how do I connect the amplifier?

You can try to connect the "AMP.CONT wire with the amplifier wire".

The problem was finding the amplifier wire, but I found it and connected it to the ANT.CONT. as it said AUT.ANT. from the car. Now it works!
  Reply